T Point Source

Line array / Point sources

2-way loudspeaker with rotatable horn for point and line source operation

• Components 2 x 6.5"/1.4"
• Dispersion 90° x 35° / 105°
• SPLmax 130 / 132 dB
• Weight 11 kg

The T10 is a passive 2-way loudspeaker housing two 6.5" drivers positioned in a dipolar arrangement and a 1.4" HF compression driver and a passive crossover network. The T10 can be used both as a line array and as a high directivity point source loudspeaker. The HF driver is fitted to a unique waveguide horn producing vertical line source directivity with a 90° horizontal pattern that is maintained down to approximately 600 Hz. An acoustic lens placed in front of the horn widens horizontal dispersion to 105°, rotation of the horn by 90° relative to this produces an accurate point source dispersion, transforming a vertically oriented T10 into a stand-alone full range loudspeaker with 90° horizontal and 35° vertical directivity pattern. The T10 cabinet is constructed from polyurethane integral hard foam, incorporates integrated line array rigging hardware and has an impact resistant finish. The front of the loudspeaker cabinet is protected by a rigid metal grill backed by an acoustically transparent foam, and two EP5 or NL4 connectors wired in parallel are mounted on the rear panel.

The d&b D20 and 30D amplifiers are recommended to drive the T10. The d&b D80, 10D and D6 can also be used.

The T Flying bracket is designed to fit tightly around the loudspeaker
to produce the minimum visual impact and can be fitted to a
loudspeaker stand using the loudspeaker stand adapter or flown
using the TV spigot with fixing plate.

The T Horizontal bracket enables the cabinets to be attached horizontally to trusses, walls or ceilings.

 

 

This adapter is used to mount loudspeakers on to the standard 35 mm diameter column commonly used for loudspeaker stands.

d&b stativadapter.

Loudspeaker stand with winder.

d&b M20 högtalarstativ med vev.

The Z5015 02 TV spigot can be used to vertically suspend single d&b C6/C690/E9 loudspeaker cabinets either directly from the telescopic lighting supports found in many broadcast studios or using a Z5012 Pipe clamp (loads up to 50 kg) fixed to an overhead bar or truss with a tube diameter between 32 and 50 mm.

The spigot may be used with a Z5016 Heavy duty Pipe clamp for loads of up to 70 kg.

The Z5029 TV spigot can be used to vertically suspend one or two d&b E3 loudspeaker cabinets in combination with the following d&b loudspeaker rigging accessories:

Z5012 Pipe clamp for TV spigot

Z5028 E3 Horizontal bracket

Z5030 E3 x 2 Angle bracket

Z5032 E3 Swivel bracket

Z5033 E3 Ball joint adapter

The Z5010 Tv Spigot with fixing plate allows certain d&b loudspeakers to be attached to the telescopic lighting supports normally used in broadcast studios.