Ti Line Array

The Ti10L loudspeaker is the installation version of the T10 for deployment as a line array loudspeaker.

 

Road and installation versions differ only in the mounting hardware. The Ti10L cabinet is a passive 2-way design that houses 2 x 6.5” drivers and a 1.4” exit HF compression driver.

 

The very compact loudspeaker design is a unique combination of a rotatable waveguide with horn and an acoustic lens.

 

It provides a vertical line source with a 90° horizontal dispersion that is maintained down to approximately 600 Hz, whilst the integrated lens in the front grill widens the HF dispersion in line array mode to 105°.

 

The two 6.5” neodymium LF drivers are positioned in a dipolar arrangement providing an exceptional dispersion control even at lower frequencies.

 

The Ti10L cabinet is constructed from polyurethane integral hard foam with an impact resistant finish and has integrated line array rigging hardware which, once deployed is fundamentally invisible when viewed from the front.

 

The front of the loudspeaker cabinet is protected by a rigid metal grill backed by an acoustically transparent foam.

 

Mounted on the rear panel are two NL4 connectors wired in parallel. Special colour (SC) or weather resistant (WR) versions are available

The T Flying frame is designed to support a maximum of twenty T10 loudspeakers and has a mounting plate that accepts inclinometers such as the Teqsas Lap-TEQ line array positioning tool. All necessary rigging components are mounted to the cabinet and slide out when needed. Splay angles between adjacent cabinets can be set in the range from 0° to 15° in 1° steps. The T subwoofer can also be attached to the T Flying frame either at the top of an array with subsequent T10 loudspeakers attached or as a column of T subwoofers.

The Z5147 Rota clamp enables the horizontal alignment of the cluster by suspending it from a single flying point using the centre plate of the mounting frame. The Rota clamp allows a WLL of 250 kg (551 lb) and can be suspended from overhead bars or truss with a tube diameter up to 51 mm (2").

T10 arrays using three cabinets can be configured using the T Cluster bracket along with a loudspeaker stand, mounted withthe loudspeaker stand adapter or flown using the TV spigot with fixing plate.

The Z5010 Tv Spigot with fixing plate allows certain d&b loudspeakers to be attached to the telescopic lighting supports normally used in broadcast studios.

d&b 1 t shackle.

• Installation specific compact flyable subwoofer
• Components 15"
• Dispersion Omni directional
• SPLmax 130 dB
• Weight 17 kg

The Ti-SUB is the installation version of the T-SUB and only differs to the road version in the mounting hardware and cabinet details. It can be used to supplement the LF headroom of the Ti10L and Ti10P cabinets in various configurations. The Ti subwoofer cabinet is an actively driven bass-reflex design housing a long excursion 15" driver with a neodymium magnet. The cabinets are mechanically connected using rigging links on both sides of the cabinet front, which slide out when needed, and with a central splay link at the rear of the cabinet. All necessary rigging components are mounted to the cabinet. The Ti-SUB can also supplement the Ti10 loudspeakers in ground stacked applications where the Ti-SUB can mechanically support them. The Ti-SUB cabinet is constructed from marine plywood and has an impact resistant paint finish. The front of the loudspeaker cabinet is protected by a rigid metal grill in front of an acoustically transparent foam. Mounted on the rear panel are two NL4 connectors wired in parallel. The loudspeaker cabinet is also available in Special Colour (SC) and Weather Resistant (WR) options.

The d&b D20 and 30D amplifiers are recommended to drive the Ti-Sub. The d&b D80, 10D and D6 can also be used.