För att ge dig bättre service använder vi cookies. Genom att fortsätta på sidan godkänner du vår användning av cookies.

Preamps

Filtrera & sortera
Antal artiklar 5
Tonebone PZ Pro
R800 7089 00
Tonebone PZ-PRO
2-Channel Acoustic Instrumental Preamp
Take complete control over your tone, EQ settings, and effects with the PZ-Pro, a two channel instrument preamp, DI and switcher. Each channel features a separate equalizer strip complete with a filter section to reduce feedback on stage. The second channel of the PZ-Pro also features a microphone input to allow any dynamic or condenser microphone to be used, including clip-on instrument mics. Three footswitches provide the ability to toggle between each input channel, activate a built-in booster and an effects loop, or mute the signal for silent tuning on stage.
  • 2 channel acoustic instrument preamp with separate EQs
  • Piezo input boosters available on both channels
  • XLR input with available phantom power on channel 2
  • Assignable FX loop with wet/dry control
Mission control for your acoustic setup
The PZ-Pro is designed for instrumentalists and performers who take a no-compromise approach when it comes to tone, both on stage and in the recording studio. Dual input channels allow you to switch between or blend together two sources, with full control over the sound of each input. Each channel has its own semi-parametric equalizer section and input level, along with individual filter controls to reduce feedback on stage. The second channel of the PZ-Pro also features a microphone input to allow any dynamic or condenser microphone to be used, including clip-on instrument mics or even vocal microphones. An FX Loop with a wet/dry knob provides the ability to blend in as much or as little pedal effects as desired, with a footswitch to bring them in and out of the signal chain at a moment's notice. Finally, once your tone is completely dialed-in, balanced XLR direct outs feed the PA system or a recording interface, with both Pre-EQ and Post-EQ outputs available.
Adaptable for any application
The PZ-Pro is highly configurable, so you can adapt it to meet the needs of your performance, instead of changing your performance to fit the limitations of your gear. Connect magnetic pickups, instruments with on-board preamps, or piezo transducers, and optimize the sound of each with powerful EQ controls and a variable notch or high-pass filter. Blend an instrument mic with your pickups, switch between two instruments, or connect a vocal microphone and feed it through your guitar pedals. The FX loop can be assigned to channel A, B, or both at once, and you can activate it with a footswitch or assign it to be always on, saving footswitch control for the variable clean boost function. With the PZ-Pro, you get the durability and performance Radial is known for, along with all the features you need to put on an unforgettable show.
Pris exkl.6 210.00
Tonebone PZ-Pre
R800 7085 00
PZ-Pre™ – pedal med förförstärkare för akustiska instrument

• Kombinerad pietzo-booster och förförstärkare
• Två ingångar: två instrument eller mix
• Parametrisk EQ och notch-filter
• Fyra utgångar: förstärkar-, stämapparat- och två DI-utgångar
• Fungerar med alla instrument!
 
Radial Tonebone PZ-Pre™ är den mest kraftfulla förförstärkaren för akustiska instrument som någonsin byggts in i en pedal.
 
Och när vi säger akustiska, menar vi inte bara akustisk gitarr; Vi menar ALLA akustiska instrument inklusive banjo, violin, cello, mandolin, kontrabas, bouzouki eller luta.
 
Det magiska i PZ-Pre ligger i kombinationen av 100% diskreta class-A piezo boosters, en knäpptyst förförstärkarkrets som kan användas med vilket pickup-system som helst och stora kopplingsmöjligheter som ger kontroll över alla situationer.
Pris exkl.3 750.00
R800 7320 00
Pris exkl.2 800.00
Tonebone Bassbone OD
R800 7072 00

The Bassbone OD is a bass preamp with two instrument input channels, each of which is fully equipped with a level control, super powerful passive-interactive EQ and a low frequency filter to help eliminate resonance.

Channel-A is equipped with a PZB booster switch that increases the sensitivity and load to 10 meg ohms to optimize it for use with piezo transducers as commonly used on upright bass.

Channel-B takes a different slant with Drag Control load correction to optimize the tone and feel when using a passive instrument such as a vintage Fender bass.

Toggling between channels is done using a footswitch and both channels may be mixed together by depressing the blend switch, should a dual pickup system be in use.

Outputs include a ¼' instrument level output to feed the artist's on-stage amplifier plus a balanced low-Z Radial DI box output to feed the PA system.

The XLR output can be assigned pre or post effects to suit the engineer's preference. A separately buffered tuner output works with the mute footswitch for quiet on-stage tuning.

For bassists that employ effects, both input channels can share the same pedals by connecting via the built-in send & receive effects loop.

This is augmented with an on-board bass overdrive with control over the drive level and tone. A wet-dry mix lets you add slight grit similar to an Ampeg SVT or full on distortion depending on your mood.

The OD footswitch may be assigned to the loop, overdrive or both. Finally, a built-in headphone amp with 3.5mm output lets you use the Bassbone on the bus for those long drives between gigs.

The Bassbone OD... the world's most powerful bass preamp in a pedal.

Pris exkl.4 190.00
R800 7071 00
Pris exkl.3 490.00

Produkten har lagts i din varukorg Visa varukorgenTill kassan